Single-Stage Deep Drawing Process Simulation Study of AISI 304 Stainless Steel Using AFDEX Software

Authors

  • Rohan Kattimani Student, Department of Mechanical Engineering, Visvesvarya Technological University, Kalaburagi, India
  • Prof. Vijayendra B. Hippargi Associate, professor, Department of Mechanical Engineering, Visvesvarya University, Kalaburagi India

DOI:

https://doi.org/10.5281/zenodo.7883918

Keywords:

AFDEX, Solid Edge V19, Die corner Radius, Co-efficient of friction

Abstract

In this research, we will investigate the material behavior of AISI 304 stainless steel in single phase deep drawing and the factors effecting. AISI 304 is amongst prevalent materials for deep drawing due to its versatility and high quality. In addition, the characteristics that affect AISI 304's deep drawability will be identified. SolidEdge V19 is used for the design and modeling of molds and workpieces. Using AFDEX, this process can be simulated and analyzed. Frictional coefficient & die corner radius are the independent factors in this study. Consistency is maintained in both the punch velocity (230mm/s) and the BHF (1265N). The cold forming type allows for a steady 25 degrees Celsius.

Downloads

Published

28-04-2023

How to Cite

Rohan Kattimani, & Prof. Vijayendra B. Hippargi. (2023). Single-Stage Deep Drawing Process Simulation Study of AISI 304 Stainless Steel Using AFDEX Software. Journal of Scientific Research and Technology, 1(1), 36–41. https://doi.org/10.5281/zenodo.7883918

Issue

JSRT Volume-1 Issue-1 April-2023

Section

Articles